1990 Acura Integra Hondata 4 bar MAP Sensor - Acura/Honda - B/D/H/F-Series & 00-05 S2000

The Hondata 4 bar MAP sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the B, D, H, F, J and K-series Honda engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors.

Important note for automatic transmissions

Automatic transmission computers for the 2009-2010 TSX, 2006-2011 R18 Civic, any CVT CRZ, Asian RRH based Civics share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor, then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs.

How do I configure my software for the 4 Bar sensor?

SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'.

FlashPro - in the 'Calibration' window under 'Sensors'.

Hondata 4 bar MAP Sensor - Acura/Honda - B/D/H/F-Series & 00-05 S2000 fits the following vehicle(s):

• Part Number fits: 4-BAR-MAP-B (87485)
• 1990 Acura Integra
• 1991 Acura Integra
• 1992 Acura Integra
• 1993 Acura Integra
• 1994 Acura Integra
• 1995 Acura Integra
• 1996 Acura Integra
• 1997 Acura Integra
• 1998 Acura Integra
• 1999 Acura Integra
• 2000 Acura Integra
• 2001 Acura Integra
• 1990 Honda Civic
• 1991 Honda Civic
• 1992 Honda Civic
• 1993 Honda Civic
• 1994 Honda Civic
• 1995 Honda Civic
• 1996 Honda Civic
• 1997 Honda Civic
• 1998 Honda Civic
• 1999 Honda Civic
• 2000 Honda Civic
• 1997 Honda Prelude
• 1998 Honda Prelude
• 1999 Honda Prelude
• 2000 Honda Prelude
• 2001 Honda Prelude